About change to using one-byte alphanumeric characters for Product name, Level names/ Component names in chemSHERPA data entry support tool for articles(Partially revised_2)

We’ve promoted the conversion from local languages (double-byte characters) to one-byte alphanumeric characters in order to meet the standards with .IEC62474 (global support).
With the cooperation of all of you, we have completed the conversion of the product name of the tool into one-byte alphanumerical characters, and then have been asking for conversion about Level names and Component names in the composition window into one-byte alphanumerical characters.
About some correspondence, we have confirmed that some users are delayed in conversion due to the large number of Components.
In order to ensure that this response is taken, we have decided to postpone some of the plans and changed the original plans as shown in the table below.
Therefore, please proceed conversion so that there is no delay with this plan.

Tool version (release)	General				Composition
	product name of requester		Product Name		Level Name		Component Name
	Entry CHK	2-byte character mode	Entry CHK	2-byte character mode	Entry CHK	2-byte character mode	Entry CHK	2-byte character mode
2.03.00 (Old version)	WARNING	OFF	WARNING	OFF	N/A	OFF	N/A	OFF
2.04.00 (Current version)	↓	↓	↓	OFF locked	WARNING	↓	WARNING	↓
2.05.00 (Winter FY2021)	↓	OFF locked	ERROR	↓	↓	↓	↓	↓
2.06.00 (Summer FY2022)	↓	↓	↓	↓	↓	↓	↓	↓
2.07.00 (Winter FY2022)	ERROR	↓	↓	↓	↓	OFF locked	↓	OFF locked
2.08 (Summer FY2023)	↓	↓	↓	↓	↓	↓	↓	↓
2.09 (Winter FY2023)	↓	↓	↓	↓	ERROR	↓	ERROR	↓

Entry CHK: Tool error check
N/A: No check is performed for other than one-byte alphanumeric characters.
WARNING: Other than one-byte alphanumeric characters will trigger a warning.( Approved data can be output)
ERROR: Other than one-byte alphanumeric characters will trigger an error (Approved data cannot be output).
2-byte character mode: Two-byte character permission mode
OFF: Only one-byte alphanumeric characters are allowed by default. Two-byte characters may be used by switching the entry mode manually.
OFF locked: Entry mode fixed to one-byte alphanumeric characters (no two-byte character mode).